Log In
January 28, 2014
Offline
Hey everyone new to the form . I’m looking for a good descending right turn bobcat form. I have looked through vandykes and Mckenzie and can’t find one I like. Here is what I have to work with for measurements
1 1/2, 14, 28. Any help would be great !
January 28, 2014
Offline
Ya I have looked at those places as well. Still unable to come up with what on looking for.
You may not find a form that fits……so you will need to ‘modify’ the form by cutting , adding, rasping, etc. I would look for a form that matched your 14 measurement. I have found this measurement was the best for me to match because the legs normally fit when I matched the middle measurement. You can cut and add length , modify the head or use a change out head. I did not do a lot of looking but Mckenzie B-0-O may work with modifications.
June 24, 2013
Offline
B great if tab hinton forms were still available!
Try to be open minded and always strive to be better!
January 28, 2014
Offline
Thank you for all the help. I do have a reference photo of a mount I liked and flipped using photo editor but a can not figure out how to post a picture from my phone.
